• 225°C maximum temperature
• Gravity-flow convection
• Electronic control

·Gentle Gravity Convection Airflow:
Air enters inlet port at bottom of chamber, passes over hating element to be warmed, and flows evenly upward through chamber for uniform heating

·Electronic Control:
Once oven is turned on, a green POWER light indicates that the power is on the red HEAT indicator light cycles on and off when the oven heaters are operating

·Three Chamber Capacities to Fit Any Lab:
Available in 2.5 cu. ft., 3.75 cu. ft. and 5.0 cu. ft. chamber capacities

·Designed to Protect Samples:
If the primary heater fails, a built-in backup will maintain control at 5°C above the setpoint while a yellow ALARM light indicates that the backup controller is operating.  A built in circuit breaker protects oven form power surges

·Built to Last:
Oven chassis is made form pre-painted steel panels; extruded aluminum trim has a plastic powder coating; chamber is easy to clean stainless steel

·Universal Applications:
Ideal for general laboratory drying, sterilization, stress testing, moisture analysis, curing, and more…

·Warranty:
All units are covered by a two-year warranty on parts, labor, and travel.  All models are CSA approved

STANDARD LAB OVENS

MODEL NO.

RECOVERY
after 1 min.
200°C

TEMPERATURE
RANGE

UNIFORMITY
(at 200°C)

EXTERIOR DIMENSIONS,
L x W x H

INTERIOR DIMENSIONS,
L x W x H

+/-5°C

60 x 65 x 66cm
23.5 x 25¾ x 26”

60 x 65 x 84cm
23.5 x 25¾ x 33”

60 x 65 x 100cm
23.5 x 25¾ x 39¼”